Demon core Installation

From flyinglemon documentation
Jump to: navigation, search

WARNING

DEMON CORE is a very simple PDB but like our others devices need some electrical and mechanical abilities.

BATTERY TIE SOLDERING

REMEMBER TO USE WIRES WITH CORRECT GAUGE, ACCORDING WITH SUMMARY CURRENT USAGE.
Compare your wires with tables HERE

Which layer (top or bottom) you choose depends on your build but remember that carbon is an excellent conductor and any wire can not touch directly to the frame.

Soldering is very simple:

  • hot (red, positive or "+") solder to this PAD:
    • on bottom side:
caption
    • on top side:
caption


  • cold (black, negative or "-") solder to this PAD:
    • on bottom side:
caption
    • on top side:
caption


ESC SOLDERING

Soldering ESC cables is very similar to soldering battery tie. Solder pads are on left and right side.

  • hot (red, positive or "+") solder to this PAD:
    • on bottom side:
caption
    • on top side:
caption


  • cold (black, negative or "-") solder to this PAD:
    • on bottom side:
caption
    • on top side:
caption

CAMERA, VTX and OSD

Demon Core allows you supply FPV camera and VTX. Also video line can be redirect to OSD (with supply PADS).
Connection diagram for system with OSD:

caption

Connection diagram for system without OSD:
When not using OSD pins "i" and "o" must be short.

No osd diagram.jpg


Voltage level (5V or 12V) for camera and VTX can be defined with solder jumpers.
Short center pad with left of right depednig desired voltage value

Solder pads.png